Replacing the Eir F2000 Router

Recently, I was lucky enough to get Fibre To The Home (FTTH) connected at my abode, and was kindly provided a wireless router from Eir. It is the Huawei F2000 (HG659b). The F2000 is reported to have lots of issues with wifi, so you might look to replace it with something else, right? Yes. Good idea.

The F2000 user guide states:

The eir F2000 eir Fibre Modem is a next generation voice gateway that supports very-high-data-rate digital subscriber line 2 (VDSL2) uplink, one Giga Ethernet uplink port and 4 Giga Ethernet downlink ports.

That all sounds great, however the VDSL2 part is overkill for FTTH. All that is connected to it is a single ethernet cable from the Eir installed Optical Network Terminal (ONT). It is the one on the left here:

That yellow cable just plugs into the WAN port of the F2000. So this is basically just IP over Ethernet. This means you can use any router you like instead of the F2000. No DSL/VDSL modem required. No PPPoe or other acronym crunching protocol needed. Just a bog standard Ethernet cable and a router which supports negiotating an IP address via DHCP (AKA every router made ever). It also needs to support setting the wan to recieve and transmit on a VLAN. Not all default firmwares will allow this, but all the major opensource ones do, such as OpenWRT/DD-WRT/Tomato.

So, for me, I happen to have a Linksys E4200v2 which I flashed OpenWRT/LEDE onto. I already had this setup with various bits and pieces I want. To connect the new fibre internet to it was simple (once I found out how!).

Basically you just need two things:

  1. Set the WAN connection to be a DHCP client
  2. set the VLAN (802.1q) tag to 10

In OpenWRT/LEDE all you need to do to make this happen is the following. Edit /etc/config/network as follows:

config switch_vlan
	option device 'switch0'
	option vlan '10'
	option ports '4t 6'

config interface 'wan'
	option proto 'dhcp'
	option ifname 'eth1'

Above you see the line option ports '4t 6' under the switch_vlan section. Here port 4 represents the wan port on my router. 6 is the interface corresponding to my eth1 interface. These numbers may differ on your OpenWRT router but are easy to figure out.

Now just do a restart. That’s it! You will see now that your wan interface will pick up a public IP address. Now throw that F2000 in the cupboard.

Settings for Vodafone FTTH

Note for Vodafone FTTH as well as VLAN tagging, you will need a router which supports PPPoe.

Here are my settings using OpenWrt on EdgeRouter X:

Settings for Sky FTTH

For Sky Ireland FTTH, the settings are exactly the same as Vodafone above except use abcdefgh@skydsl as the PPPoe username and 1234567890abcdef as the password.